How much is a yard of pea gravel?
A cubic yard of pea gravel will cover 324 square feet to a depth of one inch, equal to an 18-foot square. Divide this area by the desired depth of the gravel in inches to determine the area you can cover with a cubic yard of gravel.
How many yards is a ton of pea gravel?
Calculate 1B Pea Gravel
| Coverage (Square feet) | 400 | sq ft |
|---|---|---|
| Volume (Cubic feet) | 67 | cu ft |
| Volume (Cubic yards) | 2.5 | cu yd |
| Estimated amount (Pounds) | 5,951 | lb |
| Estimated amount (Tons) | 2.98 | ton |
How deep does my pea gravel need to be?
about 2-1/2 inches
Add pea gravel to a depth of about 2-1/2 inches. Use a garden rake to smooth high spots and fill low spots as you go. Remember, the border should be about 1/2 inch higher than the gravel to help keep the small stones in place. If you need to tamp down the gravel, use a hand tamper.
Can you put pea gravel directly on dirt?
You can lay the pea gravel directly over grass or soil, but plants will grow up through the pea gravel. Remove the hose and dig out the marked area to a depth of approximately 2 to 3 inches for low-traffic feature areas such as mulching around pots, flower borders and areas used for display only.
How many square feet will 5 tons pea gravel cover?
Most suppliers will give an approximate fill capacity in cubic feet per ton of gravel. The most general consensus of coverage is 100 square feet at a 2-inch depth. Using this amount of coverage, the typical weight of pea gravel is a ton of material.
How much will a 50 lb bag of pea gravel cover?
A 50-pound bag of pea gravel is equivalent to 0.5 cubic foot, so two 50-pound bags cover 1 cubic foot. Knowing that a 50-pound bag of pea gravel averages 0.5 cubic foot makes the calculation easy — and one most smartphone calculators can complete.
What is the difference between a yard and a ton of gravel?
1 cubic yard of gravel weight is 2800 lb, in United States, 1 ton of gravel is equal to 2000 pounds, convert tons of gravel to cubic yards = 2000/2800 = 0.714 cubic yards, so there are 0.714 cubic yards in a ton of gravel. 2.142 cubic yards is 3 tons of gravel.
How do I figure out how much pea gravel I need?
Measure the length, width and depth in feet of the area to be covered. Multiply the three numbers together. Divide by 27 to get the number of cubic yards of pea gravel needed. For example, if the area is 9 feet square and the gravel is to be a foot deep, multiply 9 by 9 by 1 to get 81.
Does pea gravel stay in place?
Preventing the Spread of Pea Gravel The two most effective methods for stabilizing pea gravel are cement and permeable pavers. If you’re stabilizing pea gravel with cement, it will hold for a while until it’s eventually damaged by traffic and water exposure.
